copper sleeve
英 [ˈkɒpə(r) sliːv]
美 [ˈkɑːpər sliːv]
网络 铜套
双语例句
- The wave-proof sleeve is a kind of shielded copper braiding sleeve for preventing the interference of electric wave or playing the effect of protection.
防波套是用于防止电波干扰或起保护作用的屏蔽铜编织套。 - The copper sleeve comprises a upper copper sleeve and a lower copper sleeve fixed inside the supporter by the coaxial;
铜套包括同轴固定于支架内的上铜套和下铜套； - By using the shielding effect of the eddy-current magnetic field, a copper shield with high conductivity was used between the retaining sleeve and magnets.
利用涡流磁场的屏蔽作用，在转子保护环和永磁体之间增加一层电导率高的铜片。 - The outer circle of the thermal fuse is riveted with a copper sleeve.
热熔断器的外圆上铆接有铜套。 - Solution for Overheat Lock Breaking of Crosshead Copper Sleeve in High Pressure Pump by Orthogonal Test Method
应用正交试验法解决高压泵十字头铜套过热抱死问题 - We have developed a continuous casting machine with dual crystallizer for compund bimetal. The machine is characterized as follow: 1, graphite sleeve set in water cooling copper sleeve;
设计和制造了1台双金属双结晶器连续铸造试验机，其特征是：①结晶器为水冷铜套内衬石墨套； - Using the coefficient of heat ( emission) obtained according to the theory of fluid similarity, the 3D temperature field was calculated. The curves between eddy loss, temperature and thickness of copper sleeve were gained.
在此基础上结合利用流体相似理论得到的散热系数，针对所建立的三维温度场进行了有限元计算，分别得到了铜皮套筒内涡流损耗、永磁体平均温度与套筒厚度之间的关系曲线。 - In order to restrain the fluctuation of speed, vibraton, and increase the ability of starting under load, a copper sleeve was mounted outside the permanent magnet rotor of U-shape single phase line-start permanent magnet motor.
为了抑制转速波动、降低振动，同时提高电机带载起动能力，在原单相自起动永磁同步电机转子外侧加了铜皮套筒。 - Probe to Replacement and Repair of Stern Shaft Liner Copper Sleeve Partially
艉轴铜套局部换新修理方法探讨 - This paper made chiefly an introduction on turning process of the thin wall copper sleeve and design of fixture structure.
本文着重介绍了薄壁铜套的车削工艺及夹具结构设计。 - This article introduces a new kind of copper, chrome and boron alloy cast iron cylinder sleeve.
介绍了一种新型硼铬铜合金铸铁气缸套。 - Development of Cu-Ti-Sn-Cr Crystallizer Copper Sleeve
Cu-Ti-Sn-Cr结晶器铜套的研制 - The Method for Assembling on Copper Sleeve of the Cylinder Head in Diesel Engine
柴油机气缸盖喷油器铜套压装方法 - Turning of The Thin-Wall Copper Sleeve and Design of Fixtures
薄壁铜套的车削与夹具设计 - Study on the Casting Process of Metal Mold for Large-scale Copper Sleeve Castings
大型铜套类铸件的金属型铸造工艺